Projects. - In this article we will give you one electronic projects categorized using Arduino UNO module for building melody shaper. Beside Arduino UNO, in this project also using other components as follow piezo speaker, transistor, resistor, capacitor and battery.
In here we will show you the Figure of melody shaper, global description, hardware and software requirement, and the last we will give you the link to continue your reading to official source.
In here we will show you the Figure of melody shaper, global description, hardware and software requirement, and the last we will give you the link to continue your reading to official source.
Electronic Project
Hardware and Software
- Arduino Uno
- Piezo-Speaker
- 2N2222 (or S8050) Transistor,
- 1K Resistor,
- 100-μF Capacitor
- 3-pin Female Header, Male-to-Male Jumper Wires, 9-V Battery
- Arduino IDE software
Description
The electronic projects like in Figure 1 above show you melody shaper based on Arduino UNO. This project is designed to will show you how to use the Arduino to play your most-loved tunes. The steps are pretty simple to follow and should get your project running within minutes.
The Arduino here creates tones of different frequencies, playing them through a connected piezo-speaker. The variation of the frequency of the tone (pitch) and the correct timing (rhythm) create the melody. Arduino-generated music signals outputted through one of its digital pins drive the piezo-speaker through a simple driver circuit. Note that you can change the melody easily by uploading a new sketch. Well, let’s get started.
And now you can continue your reading about the electronic projects melody shaper based on Arduino UNO from original or official site using link HERE.
And now you can continue your reading about the electronic projects melody shaper based on Arduino UNO from original or official site using link HERE.
0 comments:
Post a Comment