555 Circuit. - This is one of implementation of 555 IC to build monostable latch. It is only need small component to build this electronic circuit that basically using 555 and other component.
The electronic design circuit of Monostable Latch using 555-Timer is look like in Figure 1 below. Other component used like LED, resistors, capacitors, and push-button switch.
The electronic design circuit of Monostable Latch using 555-Timer is look like in Figure 1 below. Other component used like LED, resistors, capacitors, and push-button switch.
Beside we will show you electronic design circuit and component parts need, we also will give you global description about this circuit. So, please enjoy to continue reading this article until finish and get more useful.
Electronic Circuit Design
Component Parts
- IC 555
- Resistors
- Capacitors
- Push-button switch
- Diode LED
Description
The electronic circuit design like in Figure 1 above show you monostable latch circuit using 555 Timer. Other component need also that can supply with low voltage DC +12V source to charge this IC and all system component. With this electronic design circuit you can produce monostable latch that useful now.
According Circuitstoday blog mentioned that using the charging and discharging phases of RC-Circuit as a continuous voltage signal, timing circuits can be designed. When the voltage at trigger input falls from Vcc to below 1/3 Vcc the LC (Lower Comparator) sets and this, in turn, sets the RS-Latch and hence, the output is set. The voltage across the capacitor is connected to the Non-Inverting terminal of the UC (Upper Comparator) and is compared with pre-set 2/3 Vcc at the inverting terminal of the Op-Amp. When the capacitor voltage tends to exceed 2/3 Vcc, the UC sets and this, in turn, resets the RS-Latch and hence, the output is reset.
0 comments:
Post a Comment