8051 Circuit. - This is one of implementation PIR sensor to build motion sernsor light. It is only need small component completed to build motion sensor light in this time.
Beside we will show you electronic design circuit and component parts need, we also will give you global description about this circuit. So, please enjoy to continue reading this article until finish and get more useful.
Electronic Circuit Design
Component Parts
- AC/DC Adapter modula
- Capacitors
- Resistors
- PIR Sensor
- Transistor
- LED panel
Description
The electronic circuit design like in Figure 1 above show you DIY Motion Sensor Light using LED Bulb and PIR Sensor that written by Narasimha Rao.
According Circuitstoday blog mentioned that this project is a DIY Smart Light Adapter – which aims to build a smart light bulb based on your ordinary light bulb (which can be a CFL or an LED lamp) and a PIR sensor. The final output will be a light bulb that turns ON based on motion around a particular area within the range of PIR sensor attached to the ordinary light bulb. So lets begin!
If you are not willing to re-wire your home for smart lighting or not interested in spending a huge amount of money for the smart lighting system, then this DIY project is for you.
This simple adapter converts normal bulb into a smart Bulb, with the help of a PIR sensor. The mounting of the sensor is done in such a way that the angular position of the sensor can be adjusted, so that, the original position of the batten holder does not affect the sensing of human passage. This is achieved by using a 3.5 mm stereo jack and its socket. However, this type of mounting is up to your will and wish. It’s possible to wire directly without any mounting.
If you are not willing to re-wire your home for smart lighting or not interested in spending a huge amount of money for the smart lighting system, then this DIY project is for you.
This simple adapter converts normal bulb into a smart Bulb, with the help of a PIR sensor. The mounting of the sensor is done in such a way that the angular position of the sensor can be adjusted, so that, the original position of the batten holder does not affect the sensing of human passage. This is achieved by using a 3.5 mm stereo jack and its socket. However, this type of mounting is up to your will and wish. It’s possible to wire directly without any mounting.
0 comments:
Post a Comment